Energy UNITS FOR LIFT TABLE one
Basic Description
This electrical power unit is created solely for your little lift table,Consisting of high stress gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit is broadly made use of during the industry of logistic gadgets including minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is controlled from the solenoid valve with the velocity managed from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Common Description
This power unit is intended solely to the medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve as well as the velocity controlled by the adjustable needle valve. When the lift rises to a large positoin, however the energy provide is lower, the lowering motion is managed from the guide override perform.
Energy UNITS FOR LIFT TABLE three
Standard Description
This energy unit is made exclusively for the massive lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived by the solenoid valve along with the speed controlled by a strain compensated movement handle valve.
Energy UNITS FOR LIFT TABLE four
Standard Description
This power unit is made exclusively for the large lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve and also the pace managed from the adjustable needle valve. When the lift rises to a higher positoin, but the electrical power supply is reduce, the lowering movement is managed through the guide override perform.
Distinctive Notes
one. This energy unit is of S3 duty cycle, which might only function intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean the many hydraulic parts concerned in advance of set up of the power unit.
three. Viscosity in the oil shoud be 15~46 cst,which should also be clean and absolutely free of impurities.N46 hydraulic oil is encouraged.
4. Oil shifting is needed after the preliminary a hundred operation hrs,afterwards after each and every 3000 hrs.
5. The energy unit proven is created to be mounted vertically.