1.A connecting website link of an O-ring Chain for general application is pre-coated with grease on the pins. Before connection, verify the grease around the surfaces of pins, and when the quantity of grease is small, apply grease with bare hands. (If gloves are utilised, the grease will probably be absorbed through the gloves.)
Instance: When the connecting link (I) of an O-ring chain for basic application is
shipped, O-rings are fitted in the roots from the pins. In the event the O-rings come loose resulting from vibration in the course of transport, refit the O-rings in towards the roots of the pins.
In this instance, make sure you return the grease collected with the roots of the pins towards the central surfaces of your pins, much more at portion A than at portions B shown in the over illustration. (Portions A is worn due to sliding using the bushings.)
2.The chain might be most very easily linked within the teeth of the sprocket. Engage the back links at the two ends of the chain with the sprocket teeth and fit connecting pins. Should the sprocket is usually moved, the chain can also be connected on the loosened side.
three. Connecting procedure
1.Verify that O-rings are attached to the roots with the pins.
2.In case the level of grease utilized to the connecting pins is tiny, coat the pins with grease in the central portions.
3.Insert the connecting pins to the bushings from the inner links at each ends.
four.Verify that the grease is utilized towards the entire encounter in the O-ring, and match the O-ring onto the connecting pins.
five.Insert the connecting pins in to the connecting plate and even though pressing the connecting plate, set up the spring clip. Confirm regardless of whether the head (the finish without a split) of the spring clip is turned from the feeding direction of the chain. (See the next illustration.)
6.Be sure you confirm that the spring clip is securely fitted during the clip grooves in the connecting pins.
This completes jointing on the connecting hyperlink. Note that grease over the surfaces of connecting pins and O-rings is often removed through installation do the job. In this instance, re-grease using the grease within the surface with the base chain or the grease during the polyethylene bag in which the connecting hyperlink was contained.