Select Page

C Sort Flex-Flex Couplings
The C Form coupling includes two flex hubs, one sleeve and one particular accessory kit consisting of seals and snap rings.
CFR Style Flex-Rigid Couplings
The CFR Kind coupling include one particular flex hub, one rigid hub, one sleeve, one particular accessory kit consisting of seals and snap rings.
Basic and economical type of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in location
Offered as vertical and horizontal couplings
Wide number of special variations including full-flex, flex-rigid mill motor
Conventional configurations are available of your shelf
Ordering Information
Application: Driver and Driven.
Style and size of coupling, horizontal, vertical and so forth.
Energy: Motor horspower or torque requirement.
Speed: Motor RPM or Driven RPM.
Distance among shaft ends (BSE).
Shaft sizes.
C and CFR Sort Couplings
Ordering Data
Puller Holes are conventional on sizes 4 via 12.
Puller Holes can be found for sizes 7/8 as a result of three.5 at an additional charge.
The BSE (distance Between Shaft Ends) might differ involving G and G1.
Interference bores without any set screws are regular unless otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, consult Engineering Section.
Larger sizes can be found, please talk to Technical Support.