Materials Handling Power UNIT 2
This energy unit features energy up gravity down circuit. Activate the start out solenoid to start the motor to lift the machine. The lowing motion is activated from the solenoid valve with the decreasing velocity managed through the pressure compensated movement handle valve. Merchandise of this series could be extensively utilized in the field of logistic products such as fork lift, mini lift table, and so forth.
one. The duty of this energy unit is S3,i.e.,30 seconds on and 270 senconds off.
two. Clean the many hydraulic parts concerned in advance of mounting the electrical power unit.
3. Viscosity in the hydraulic oil shoud be 15~46 cst,which really should also be clean and free of impurities, N46 hydraulic oil is encouraged .
four. Oil changing is required right after the initial one hundred operation hrs,afterwards after every single 3000 hours.
five. The power unit need to be mounted horizontally.
Material Handling Energy UNIT 1
This energy unit is developed to the fork lift field, consisting of highly effective gear pump, DC motor, manual raise and decrease valve, tank, ect. The up and down motion are controlled from the lever of the manual release valve, which can be outfitted with an electrical switch to activate the motor. The lowing speed is controlled by the pressure compensated flow management valve.
1. The duty of this electrical power unit is S3, i.e. thirty seconds on and 270 senconds off.
two. Clean all of the hydraulic components concerned prior to installation of the energy unit.
three. Viscosity with the hydraulic oil shoud be 15~46 cst, which need to also be clean and free of impurities, N46 hydraulic oil is suggested .
four. Oil changing is required right after the preliminary 100 operation hours, afterwards the moment just about every 3000 hours.
five. The electrical power unit shown is intended to be mounted horizontally.